Buy the Tormek T-4 Original, get the SE-77 Square Edge Jig and the SQ-90 Tormek Square Free!
Limited Time Offer
While Supplies Last
T-4 Original with Free Square Edge Jig and Square
For a limited time, buy a Tormek T-4 Original now and get the SE-77 Square Edge Jig($90 value) and the SQ-90 Tormek Square for free! Available throughout September, while supplies last.
Tormek T-4 Water Cooled Grinding Machine
A cast zinc top, gives the TORMEK T-4 a high level of precision. Vital functions including the motor, the main shaft, and the integrated sleeves for the Universal Support are mounted directly in the zinc casting. This advanced design ensures stability and unbeatable precision for the Universal Support, which is the foundation of the Tormek jig system.
Innovations Include
The Universal Support sleeves are integrated into the cast zinc top and their holes have a new stadium shape. The resulting precision is a 300 % improvement over the previous design.
The handle makes the machine easy to place and move, so you are not tempted to lift the machine with the Universal Support!
Vital parts including the motor and the main shaft are integrated with the zinc cast top.
The machine plate is magnetic, making it a convenient place to store the Tormek AngleMaster (which has magnetic feet).
Ideal for Home and Hobby Use
The T-4 is a high quality machine ideal for home and hobby use which can sharpen all the common edge tools. Configure the T-4 with your choice of jigs according to the tools that you are choosing to sharpen. The jigs are sold separately.
The T-4 model is delivered with these accessories:
5 years + additional 3 on registration for home use 2 years for professional use
This motor is designed to work on 120V, we do not offer any 220V models and are unable to ship electric sharpeners outside the USA.
SE-77 Square Edge Jig
The SE-77 comes standard with the Tormek T8 and is also available independently. It is a further development of and replacement for the previous model, the SE76. This jig is used with chisels and plane irons to produce edges that are 90 degrees to the tool. The improvements to the SE77 allow not only for fine tuning of the edge to ensure a perfect 90 degrees, but also for grinding the edge to a slightly convex shape.
This ability to fine tune and grind convex edges comes from the introduction of an adjustable side to the jig. Two small knobs control the position of one side of the jig. By loosening one and tightening the other, a pendulum action is introduced. Using this action, the blade can be moved to a precise 90 degree positioning and locked in place or swung back and forth to produce a convex edge if one is desired.
The jig comprises an upper base with a lower clamp and two locking knobs for fixing the tool. The jig slides on the Universal Support on nylon bushings across the grindstone. The edge angle is set with the Micro Adjust (3) on the Universal Support (4).
There are two safety stops to prevent the tool from slipping off the stone when grinding. One inner stop (1) is to be positioned according to the width of the tool and one outer stop (2) is mounted on the end of the Universal Support.
The jig lines up the chisel to its upper flat side, making it easier to mount it square to the wheel. Conventional jigs need manual alignment.
The lower clamp has a ridge in the center enabling shorter tools with a tapered shank to be firmly mounted, e.g. Japanese chisels. The upper base, which lines up the tool, is designed so the clamping pressure is distributed to the ends and the tool mounts firmly without a heavy tightening of the knobs.
SQ-90 Tormek Square
This special square is 2 3/8" x 1 1/2" (61cm x 39cm). Made of the same zinc that is used to make the machine housings, it containes five notches for measuring common angles.
